Troubleshooting
Why does my gauge reset to the default color after I turn my vehicle off?
If your gauge is re-setting back to the factory Blue color, we recommend taking the following steps: The first thing we would suggest checking is the Constant power wire of the gauge power harness. This wire should be going directly to a constant...
Why is my Pressure Gauge pegged at the maximum reading even though everything is wired correctly?
Glowshift Gauges are designed to go to the max pressure when the gauge is experiencing a connectivity issue between the Gauge and Sensor itself. This can mean the sensor is not connected, the harness from the gauge to the sensor is damaged and or...
Why is the warning light flashing on my Elite 10 Gauge when my engine is running?
The little red light on the near the bottom right-hand side of the gauge is a warning light. If this light is flashing this means the needle of the gauge is within the programmed warning level. To change the High and Low warning settings, please...
What should I do if my GlowShift gauges are not powering on after installation?
If after your installation, the gauge(s) are not powering on, we would highly recommend going back through your wiring on the gauge power harness wires. If you are using an expandable circuit to get power from your vehicle’s fuse panel, ensure you...
What should I do if my GlowShift pod is not sitting or fitting correctly?
If your complete replacement pod is not sitting correctly, we would suggest removing the pod and ensure you have removed the vehicle's weather stripping before re-installing the pod. If you are still having fitment issues, loosen the mounting...
Why is my gauge only displaying a dim red light?
If your gauges are only displaying a dim red color, there are typically two possible causes. The most common cause is that the 12V constant power wire is not receiving power. If multiple gauges are experiencing the same issue, check the constant powe
Why is my gauge button stuck, and how can I change the gauge color?
If the button on your gauge is stuck and you cannot change the color, the bezel (trim ring) may be slightly twisted and pressing against the button. To correct this, gently rotate the bezel in the opposite direction of the button's lean:. If the butt
How can I troubleshoot my EGT Sensor if it is not working properly?
If your EGT Gauge is displaying an incorrect reading or you suspect an issue with the EGT Sensor, begin by inspecting the sensor and wiring for any visible damage. Check the entire EGT Sensor wire for cuts, pinching, kinks, burns, or other damage. In
How can I test my Transmission, Oil, or Water Temperature Sensor to determine if it is working properly?
To test the resistance of your Transmission, Oil, or Water Temperature Sensor, you will need a digital multimeter. Set the multimeter to the 20,000-ohm scale and follow these steps:. Place the red multimeter lead on the white wire of the temperature