What adapters and information are needed to install GlowShift Gauges in an LS-swapped C10?Updated an hour ago
If you are performing an LS swap on your C10, the only adapters typically needed for the gauges are for the Oil Pressure and Water Temperature Sensors.
The Tachometer can use the tachometer output from the ECU. For the Speedometer, you can use the vehicle’s Vehicle Speed Sensor (VSS) output, but you will need to know the VSS pulses per mile (PPM) to properly configure the Speedometer.
If your LS-swapped C10 does not have a VSS, you can add a GPS Speedometer Adapter or a 16-Pulse Speedometer Sensor Adapter to provide a speed signal to the Speedometer.
16-Pulse Speedometer Sensor Adapter for GM Vehicles
The factory fuel level sending unit can also be used with the appropriate GlowShift Fuel Level Gauge.
GlowShift offers an LS Swap Sensor Thread Adapter Kit for installing the Oil Pressure and Water Temperature Sensors on an LS engine.